-
1, How to select or design the driver circuit of the switching power supply? 2, ir2127s driver always burns out 3, Wha...
-
1, How to select or design the driver circuit of the switching power supply? 2, Single chip drive mos tube and power c...
-
Yes, less than 40mA. It depends on the speed of your signal. It is not recommended to use the op amp on MHz. Add a MOS t...
-
You can directly use 555 timing to form a trigger signal of dozens of K, drive a high-power MOS tube to control the tran...
-
If the switching speed is not high, the 5V microcontroller can directly drive the MOS tube, and add a level of ordinary...
-
MOS drive bootstrap circuit is a kind of drive circuit commonly used in half-bridge and full-bridge topology, which can...
-
oneSupply voltage aspectOvercurrent ------- the junction temperature caused by continuous high current or instantaneous...
-
Gate resistance in MOS tube is mainly to control the flow of current and achieve voltage regulation. In the MOS tube, t...
-
One of the most common mistakes made when calculating the gate drive current is to confuse the input capacitance (CISS ...
-
This is determined by the characteristics of the MOS tube, the input impedance of the MOS tube is very large (there is a...
