Xiaomi can't connect to the wifi problem
First, find the \"Security Center\" in the desktop icon and click on it.
On the Security Center main page, scroll down and find \"Network Diagnostics\" (at the bottom).
Once found, click to go to \"Network Diagnosis\".
Once in network diagnostics, open the type of network you want to diagnose (for example, WIFI or data network). Note that if the item \"Xiaomi Assistant Sharing Internet\" on the phone is gray, it indicates that the item is not available in the current state. In addition, if you click \"Start Diagnosis\" without currently turning on any network type, a prompt will pop up asking you to turn on the network switch first.
In addition, it should be noted here that after opening or closing the network switch here, the network switch in the setting will also be turned on or off; In contrast, after the corresponding switch is turned on or off in the Settings, the switch here will also be turned on or off.
After selecting the network type, click the \"Start diagnosis\" button to automatically scan for network faults. This time is usually very short, usually just a few seconds.
Finally, a specific suggestion is given for the problems existing in the current network. Of course, if the network is connected at the time of detection, it will be displayed as network normal.
1, first please confirm whether the broadband is suspended due to arrearage, if so, please recharge first;
< br >
2. If the fault of mobile broadband is not caused by arrears, it is recommended to operate in the following ways:
< br >
(1) Restart the optical cat, and plug the optical fiber connector again, and then test the Internet;
< br >
(2) Determine the status of the optical cat indicator, such as the WAN indicator is steady on or blinking when the port is connected to the cat normally;
< br >
(3) Remove the router, create a broadband connection, and reconfigure the router;
< br >
(4) If the above methods still cannot be solved, you can dial the local 10086 for broadband reporting.
1, if there is a conflict, you have to turn off and restart the Wi-Fi connection.
2, find the notification bar on the home screen, and then long press the icon of data connection, enter the \"mobile network Settings\" option, and then turn the \"mobile data network roaming\" option off, so that in the absence of wifi will not run traffic.
3. Enter the [WLAN] setting and turn it on. After turning it on, it will automatically find which wifi networks are currently available and select the wifi you want to connect.
4, select one of the wifi network will pop up the password box, enter the correct password.
5, if you have been getting an IP address when connecting to the wifi network, you may wish to restart millet once.