When the lamp is not bright, the first place to check is the tungsten wire in the lamp, because this is the most common reason for the lamp is not bright. So if once the lamp is not bright because the tungsten wire is burned out, you only need to replace a new tungsten wire.
Breaker break
Then check whether there is a problem with the circuit breaker, because once the circuit breaker is burned out, it will lead to a problem with the circuit. Therefore, it is necessary to test whether the electric pen can be powered on normally, and if there is a problem, it needs to be replaced immediately.
The fuse of the electric brake is burnt out
If there is no problem with the circuit breaker, then you can check whether the fuse of the switch is burned out. If the fuse in the switch is blown, a new fuse will need to be replaced.
wiring problem
If the fuse of the switch is also intact, you need to check the wiring in your home. See if any of the lines are broken, causing the lights to go off. It is possible for rats to bite the wires, so you need to find the broken place and tape it up.
The purpose of the lantern on the wedding day is to pray for good luck, and it also symbolizes the meaning of a long marriage, but there are many accidents in life, which may be turned off until the lamp is turned off
In the past wedding, people are used to burning, happy candle, happy candle is also the possibility of being blown out by the wind, as long as it is found to re-point on the future marriage will not bring any negative impact
In some areas, it is believed that the candle is a symbol of the newlywed couple, and if the candle is extinguished, it means that the marriage is not lasting, which is completely without evidence
Some wedding lights are not on is not installed.
Marriage is a big happy event, but it is inevitable that some things are not arranged thoughtfully, this is very normal, the light is not bright on the re-installation do not think too much, you think back, the marriage has some unsatisfactory places, such as some things forgotten, some cars are not timely, these are expected things.
Probably because the wiring to the lights shorted out