What are the methods and operation steps of the burner?
The burner is a tool for writing data to programmable integrated circuits, and the burner is mainly used for programming (or brush writing) of chips such as single chip microcomputer (including embedded)\/memory (including BIOS). The burner mainly modifies the program in the read-only memory, and the burner is usually connected to the computer and then used with programming software.
< br \/ >
Usage: The basic configuration of the data copy operation of the memory using the burner is: a computer (the burner has not high requirements for the computer, in general, as long as it can run the Windows 98 operating system), a burner and the driver software matched with the burner. General operation step
< br \/ >
As follows:
< br \/ >
① Connect the burner to the computer. Different burner and computer connection is not the same, some burner is connected to the computer parallel port (printer interface), some is connected to the computer serial port (COM1 or COM2), and some use USB interface (such as RF910). From speed
< br \/ >
The USB port is the fastest, the serial port the slowest.
< br \/ >
② Install the driver software matching with the burner on the computer, and set the burner as required.
< br \/ >
③ Run the burner driver software. The figure shows the operating interface of the RF910 driver software. Select the memory model.
< br \/ >
④ Operate the burner driver software to read the required data stored in the computer as a data source.
< br \/ >
There are two ways to obtain the memory data source: the first is to find a normal display of the same model as the faulty machine, remove the memory, plug it into the burner, read out the data, and save it to the computer; The second is to make direct use of the memory data already stored in the computer (which can be
< br \/ >
Previous data backups made by yourself, data provided by manufacturers or data downloaded from the Internet).
< br \/ >
⑤ Insert the blank memory (or the memory that has been used) into the burner, operate the burner driver software, and the burner writes the normal data into the blank memory.
< br \/ >
⑥ Replace the new memory of the written data to the faulty machine.
1, put the IC must be careful to avoid damage to the IC and burning seat;
2, IC must not be installed, remove the plate of the IC must first check whether there is a tin short circuit on the pin, otherwise it is easy to damage the burning seat;
3, burning personnel must be trained to operate, burning must not be able to move other computer programs;
4, such as adverse phenomena immediately feedback management to solve.
Third, IC chip burning procedure steps and methods
1, first connect the data line of the burner, and load the corresponding IC base into the burner; Power on the computer and burner;
2. Run the burning software: double-click the icon \"GANG-08\" with the mouse (different burning seats correspond to different burning software);
3, select the IC brand: after the program start screen appears, click the \"Device\" menu, call up the IC brand selection table, and then select the corresponding brand to burn the IC, and then click \"OK\";