To check the 6AT transmission oil level of the Haval H9 model, you can follow these steps:
< br >
1. Ensure that the vehicle is in a horizontal position: Before checking the transmission oil level, ensure that the vehicle is parked on a level ground to obtain accurate measurement results.
< br >
2. Open the hood: Pull the hood release handle to unlock and open the hood.
< br >
3. Locate the transmission dipstick: Locate the transmission dipstick in the engine compartment. Transmission dipsticks usually have yellow or red handles and are marked " ATF" (Automatic Transmission Fluid).
< br >
4. Clean dipstick: Use a clean cloth or paper towel to clean oil stains or dirt on the transmission dipstick.
< br >
5. Insert and remove dipstick: Insert the transmission dipstick into the specified jack, and then pull it out. Note the marks and marks on the dipstick.
< br >
6. Check the oil level: Observe the part of the transmission dipstick coated with lubricating oil. The lubricating oil should be at or near the position marked on the scale line. If the oil level is too low, it is necessary to add an appropriate amount of transmission oil.
< br >
7. Add lubricating oil (if necessary) : If the oil level is too low, you need to add an appropriate amount of transmission lubricating oil. Before adding lubricating oil, make sure to use the correct model and specification and add it according to the requirements of the vehicle manufacturer. Normally, the lubricating oil should be added from the filling hole at the bottom of the transmission oil. Please use specific tools or devices to achieve accurate additions.
< br >
8. Close the hood: Close the hood and make sure it is fully locked.
< br >
Please note that the above steps are for reference only and may vary by model and vehicle manufacturer. To ensure accuracy and safety, it is recommended to refer to the specific steps and precautions provided in your vehicle's instruction manual.
To check the 6AT oil level of the Haval H9 transmission, you need to park the car on a level ground, start the engine and put the shift lever in P gear.
Then open the hood, find the transmission dipstick, pull it out and wipe it clean, plug it back into the oil pan and remove it, and see if the oil level is between \"H\" and \"L\".
If the oil level is lower than the \"L\" line, the specified transmission oil should be added and added slowly, while checking whether the oil level reaches between \"H\" and \"L\".
Finally, insert the dipstick back in and pull it out, and check again that the oil level is correct. Be careful to use the correct transmission oil, do not add too much or too little, so as not to affect the transmission performance.
First pull out the dipstick, wipe the oil stain on the dipstick with a rag, and pull it out in the catheter, you can observe whether the transmission oil level is in the normal position by observing the trace of the oil level on the dipstick.