1. Whether the mobile phone model supports wireless charging OR whether the wireless charger matches
< br >
Wireless charger sometimes put up no response, first of all, depends on the mobile phone model support, do not need to install wireless charging coil.
< br >
a. Mobile phone built-in wireless charging receiver: directly on the wireless charger can be charged, such as Samsung S6, Nokia Lumia920, Google Nexus4\/5 and so on.
< br >
b. Wireless charging receiver contacts are reserved inside the mobile phone: wireless charging receiver coils need to be installed to achieve wireless charging, such as Samsung's S3\/S4\/Note2\/Note3.
< br >
c. The mobile phone itself does not support wireless charging at all, and it is necessary to install a wireless charging receiving back frame to achieve wireless charging, such as Apple's iPhone5\/5s\/6\/6s.
< br >
2. Whether the wireless charger indicator light is displayed normally
< br >
Secondly, there are LED lights around the well-known brand wireless charger, when the mobile phone is charged on the wireless charger, the LED lights around the wireless charger will light up, or some prompt tone, showing the use status. Sometimes it is slow, it takes a few seconds to charge, and sometimes it has to be replayed.
< br >
3, mobile phone protective shell and other external factors of wireless charger
< br >
Then, please check whether the back center of the mobile phone is placed in the center of the wireless charging board, and check whether there is inclusions between the mobile phone and the wireless charging board, it may not be able to charge normally; Check the back shell of the phone again. If the protective phone cover used is too thick, it may hinder wireless charging. It is recommended to remove the phone cover and try to charge it again.
< br >
4, wireless charger to work normally need to meet the conditions
< br >
Finally, the transmitter power of the wireless charger may also lead to the reason why wireless charging can not be used. The receiver output short-circuit current can reach 1A, the actual charging is only about 0.3, plug in the mobile phone voltage directly dropped to 3.9V, this voltage can not reach the rated voltage to charge the mobile phone, and the maximum working current of the wireless transmitter is only 600ma, smart phone charging needs more than 700ma~800ma. Therefore, the transmission power of the wireless charger is too small, and it will also make the charge not go in
There are many temporary reasons for wireless charging, one is that the operation is affected, it is temporarily disabled, the other is an accidental power failure, and another reason is that the equipment is faulty
I think it's full, or the charger's broken.