1, if the spirit is not working, or the sensitivity is not enough, it is likely to be due to the battery is out of power, if the use is a general No. 5 or No. 7 battery, you can replace a new try;
2, open the camera of the mobile phone to the infrared module of the remote control, press any key on the remote control, see whether the white light is emitted, if you can see, it means that the remote control can be used normally;
3, if the remote control of a key failure, may be due to poor contact on the circuit board, you can disassemble the remote control, wipe the metal contact on the circuit board with a rubber;
4, after the above exclusion, the set-top box still can not be normal remote control, may be due to the problem at the receiving end of the set-top box, you can only consult the after-sales service personnel of the set-top box, contact maintenance or direct replacement;
5, in addition, you can also download the mobile phone remote control software control, the method of connecting the TV is also very simple, the condition is that the mobile phone and the box in the same wifi network, the mobile phone download and install the software to open the software search device IP address, confirm the connection, at the same time, the mobile phone will automatically push the box to install the software, and then you can remote control the connected device;
battery
2. If the remote control, water, sprinkle water, first deduct the battery, then disassemble, blow with a hair dryer, and then install it can continue to use.
3. If a key (basically the middle OK key) fails, after disassembling, the corresponding key position will be pad with something (sometimes useful), in this case, try to replace the remote control.
4. In the case of remote control loss or complete damage, if there is a millet mobile phone (or a mobile phone with infrared function) download universal remote control can directly control the network set-top box.
5. If the phone does not support the infrared function, download the Wukong remote control directly and directly control the network set-top box. (Other remote control software also works.)
6. Plug the wireless mouse receiver directly into the USB, and control the network set-top box with the mouse.
First, make sure the battery in your remote is charged. Sometimes low battery power can also cause the buttons to be insensitive.
2. Then, hold down the \"set-top box power button\" and the digital key \"1\" on the remote control at the same time for 8 seconds, and the indicator light will turn into a rapid flash and then go out, indicating that the unified code value of the master remote control will be switched.
3. At this time, the general TV and set-top box are opened, then the remote control can be used normally.
4. In addition, if it still can't be used, you can try to hold down the \"set-top box power key\" and the number key \"2\" at the same time.
Indicates the switch to the first set of Unicode values.
There is also a second set of remote control standby unified code value, while holding down the \"set-top box power key\" and the number key \"3\".