The non-AC igniter power supply line of the motorcycle generator can be connected in the following way: directly connected to the positive and negative terminals of the generator.
This ensures that the igniter can work properly and has a stable power supply. In addition, it is also necessary to ensure that the quality of the connection line is good to avoid problems such as current instability or short circuit of the line.
Motorcycle generator no AC igniter power supply line needs to be directly connected to the positive and negative terminals of the generator, because the igniter is an important part of the motorcycle ignition system, responsible for providing the ignition signal to start the engine. In order to ensure that the igniter can work normally, a stable power supply is needed, and the generator is one of the main power supplies of the motorcycle.
When wiring, it is also necessary to choose the appropriate wire specifications to ensure that the current can be transmitted smoothly, and to avoid safety problems such as overheating or short circuit caused by too much current.
In addition, attention should also be paid to the fastness of the wiring to prevent poor or loose contact from interrupting the current or causing the igniter to not work properly.
If you are not sure how to properly wire, it is recommended to consult a professional or refer to the circuit diagram of the motorcycle.
Different brands, the wiring color meaning is also different, first confirm your igniter and the car is matched, the type is consistent, and then you can wire. If you say that the thickest line of the igniter connected to the high voltage pack is correct, the other lines, the magneto outlet, the black\/red line is the ignition coil, the black\/red line of the contact igniter, the pink and yellow are the charging line, the access rectifier, the green and white and blue and white are the trigger coil wiring, respectively corresponding to the black and red and white lines of the igniter, the black and white line of the igniter is generally the extinguishing line of the key switch. However, in some models, it is also possible to ground the wire, and the black wire is used as the flame out line, and the magneto trigger coil is only connected with the red\/white wire.