First fasten the socket panel to the embedded socket box with screws, and then plug the screw holes with two plastic caps.
As long as you use a small screwdriver to pry out the plastic cap, you can remove the panel and connected socket, pull it out and use a screwdriver to unscrew the wiring screw, remove the wire, and the socket will be removed.
The other is that the panel is fastened on the socket body, and the surface can not see the trace of the screw hole.
At this time you can see that there is a small gap on the side of the panel, use a flat-head screwdriver to pry open the side of the panel at the small gap, the panel is removed, and then use a screwdriver to unscrew the screw fastening the socket body, you can pull out the socket body, and then remove the connected wire, the method is the same as above
First we need to prepare these tools: carving knife, stainless steel double scraper, screwdriver. The steps are as follows:
1. First expand the gap on one side with a carving knife.
2. Use a stainless steel scraper to slowly pry open one side and fix it, then take out another stainless steel scraper to pry up the other side, and finally let all four sides pry open.
3. Remove the bottom plate with your hand.
4. Remove the screws in the middle of the circuit board with a screwdriver.
5, the final degree can see the complete circuit board, disassembly is completed.