The steps are as follows:
< br >
1. Confirm the vehicle battery status: Before giving other cars a ride, ensure that the deep blue SL03 battery has enough power to ensure that it will not affect its own vehicle during the ride.
2. Prepare the wire: you need to prepare a set of wire, usually including red and black two clips, red is used to connect the positive terminals of the two cars, black is used to connect the negative terminals of the two cars.
3. Connect the cable: Connect the red clip to the positive terminal () battery terminal of the dark blue SL03, and connect the other end to the positive terminal () of the vehicle to be hitched. The black clip is then connected to the negative (-) battery terminal of the dark blue SL03, and the other end is connected to the ground point of the engine or body of the vehicle that needs to be powered to ensure that the current can flow.
4. Start the vehicle: Start the engine of the Deep Blue SL03 and let the battery start providing power to the other car.
5. Check the instrument panel: During the powerup process, always pay attention to the instrument panel of the dark blue SL03 to ensure that the battery power is not too low, so as not to affect the normal use of your vehicle.
6. Disconnect the cable: Once the battery of the other car is successfully started, the black clip should be disconnected first, and then the red clip should be disconnected to prevent short circuit or damage to the battery.
< br >
Please note that the above steps are for reference only, and the specific operation needs to be carried out according to the actual situation of the vehicle and the use instructions of the cable. If you are not familiar with electrical knowledge or operating procedures, it is recommended to seek the help of a professional to ensure safety and correctness.
The Deep Blue SL03 is a new energy vehicle with advanced battery technology and an efficient motor system. However, on how to give other cars a ride, which involves the mutual assistance of the car battery rescue, the deep blue SL03 ride may be different from other traditional fuel vehicles. Since the Deep Blue SL03 is a new energy vehicle, its battery type and charging method may be different from the fuel vehicle, so the direct use of the deep blue SL03 to the fuel vehicle may not be feasible.
< br >
Usually, connecting the batteries of the two cars with a cable, using the battery of one car to provide power to the other car. However, the battery type and voltage of new energy vehicles may not be suitable for this kind of power.
< br >
If you do need to give another car a lift, it is recommended to seek professional rescue services or consult the official after-sales service of the Deep Blue SL03. They can provide you with electric solutions for new energy vehicles or recommend suitable rescue services.
< br >
In addition, for new energy vehicles, especially models such as deep Blue SL03, the correct use and maintenance of batteries is very important. It is recommended to follow the vehicle's manual and official instructions to ensure the safety and long-term use of the battery.
< br >
In short, if you need to give another car an electric ride, it is best to seek professional help to ensure safety and effectiveness.
Deep Blue SL03 is an electric vehicle, if you need to give other cars a ride, you can operate through the following steps:
< br >
First of all, ensure that the deep blue SL03's power is sufficient, at least to maintain more than 50%, so as to avoid the lack of power in the process of its own normal driving.
Open the trunk of the Deep Blue SL03 and find the charging device and emergency starting cable that comes with the car.
Connect one end of the emergency start cable to the charging interface of the dark Blue SL03 and the other end to the charging interface of the car that needs to be powered.
Start the Dark Blue SL03 and set the vehicle to power mode. The specific operation method can refer to the vehicle manual or contact Shenlan automobile customer service consultation.
Make sure the connection is correct, try to start the car that needs to be powered. If it is successfully started, the other party's vehicle can be run for a period of time so that its battery is charged to a certain amount of electricity.
After completing the power-on, first turn off the power supply mode of the dark Blue SL03, then disconnect the emergency starting cable, and finally withdraw the charging device.
< br >
It is important to note that when giving other cars a ride, ensure that the operation is safe and follow the correct operating process. If in doubt, it is recommended to consult professional technicians or car manufacturers.