Electric chuck is a mechanical fixture used to grip the workpiece, if you need to disassemble and clean, you can follow the following steps:
< br >
1. Stop the power supply: Before removing the electric chuck, stop the power supply and unplug the power plug to ensure safety.
< br >
2. Disassemble the workbench: If the electric chuck is installed on the workbench, the workbench needs to be disassembled to facilitate better cleaning of the chuck.
< br >
3. Remove the chuck: Use a wrench or special tools to remove the chuck body, and pay attention to prevent finger clamping when removing.
< br >
4. Disassemble the claw: Use a wrench to remove the claw on the chuck, under normal circumstances, the claw can be divided into two parts, the upper and lower parts can be separated.
< br >
5. Cleaning: Clean the removed jaw and chuck body respectively, you can use cleaning agent and water to clean, be careful not to damage the chuck surface of the jaw.
< br >
6. Inspection and assembly: After cleaning, check whether the surface of the chuck and the claw are damaged or deformed. If there is a problem, it needs to be replaced in time. Then assemble the chuck and jaw in reverse order.
< br >
It should be noted that the electric chuck is a precision mechanical equipment, and care needs to be taken during disassembly and cleaning to avoid damage or misoperation leading to safety accidents. If you are not familiar with the method of disassembling and cleaning the electric chuck, it is recommended to ask a professional to perform the operation.
1. Loosen the locking screw, and take out the upper claw and T-nut.
2. Take out the dust cover
3. Separate the pull rod nuts from the pull rod using a socket wrench.
4. Loosen the screws fixing the chuck and remove the chuck.
5. Remove the pull tray from behind the chuck.
7. Remove the rear fixing cover from the pull tray, and remove the pull rod nut.
The general simple cleaning lathe chuck is to remove the claw and clean the chips inside the chuck with a brush.
< br >
In order to thoroughly clean the chuck, it is necessary to remove the chuck, remove the cover plate behind the chuck, take out the things inside, and clean up one by one, so that the cleaning is the most thorough.