< br >
1: Cut the power! The washing machine is disassembled in place, because the back also needs to use power and drainage. Loosen the screw counterclockwise with a screwdriver, and remove it by holding the raised blade up with both hands. If there's water that's slippery, just dry it off. It's easy.
2: The back of the removed blade is like this, it has been cleaned once before, and it is still so dirty, when it is taken off for the first time, it is hard to look at it
3: After the blade is removed, there are 4 screws here, I can use a screwdriver to unscrew this, most of them need a wrench to unscrew, if there is a hexagonal wrench of the same size, it is easier.
4: The outer side of the washing machine left and right one such screw, pry open the shell, screw off. There's two more in the back. Take them off, too.
5: After unscrewing the outer 4 screws of the upper cover, you can lift the upper cover, this time be very careful! The top cover can't be completely removed, it can only be turned back, and all the back needs one such support
6: The top cover can not be completely removed because there are water pipes and wires connected, we do not mess with these lines, keep this state can be. At this time, you will find that there is a lid on the barrel, unscrew 4 screws, lift 4 small buttons, it is easy to take off.
7: If you unscrew the four screws under the blade in the third step, then shake the inner barrel at this time, the inner barrel is lifted out, we usually see the inner wall of the inner barrel, think it is very clean, in fact, the outer wall is very dirty, and the bottom
< br >
8: After the inner bucket is removed, you will see the dirtiest outer bucket! I've already washed it once before and I'm sure you were many times dirtier than me when you first opened it! Do not take off the outer bucket, because it is still connected to the drain pipe and the power cord, which is more complicated