1. Turn off the water source: Before you begin removing the Dalton water purifier, make sure to turn off the water source to prevent leaks.
< br >
2. Disconnect the power supply: Turn off the power supply of the water purifier to ensure safe operation.
< br >
3. Remove the water storage tank: According to the Dalton water purifier model, remove the water storage tank from the water purifier. You may need to use the equipped screwdriver or wrench to loosen the bolts or clamps holding the water storage tank in place.
< br >
4. Remove the filter element: according to the Dalton water purifier model, remove the corresponding filter element. Refer to the installation guide for the correct removal sequence and method. Usually, you need to unscrew the bolt or knob that holds the filter cartridge in place.
< br >
5. Disassemble the wastewater discharge system: According to the model of Dalton water purifier, remove the wastewater discharge system (such as wastewater discharge pipe) from the water purifier.
< br >
6. Disassemble water inlet system: According to Dalton water purifier model, disassemble water inlet system. This usually includes pipes and connectors connected to the water purifier.
< br >
7. Remove other parts: According to the model of Dalton water purifier, remove other parts that may need to be replaced, such as drainage pump, pressure cap, etc.
< br >
8. Clean and save the removed parts: After the disassembly is complete, clean up the debris generated during the disassembly process. Save the removed components in the installation sequence and type for subsequent installation.
< br >
Please note that the disassembly process may vary slightly for different brands and models of Dalton water purifiers. Before proceeding with disassembly, be sure to consult the installation instructions of the Dalton water purifier you purchased to ensure proper disassembly. If you are not confident in your disassembly skills, seek professional help.
< br >
Dalton water purifier removal steps:
1. Separate the upper and lower sections of the filter element of the water purifier, and then rinse the upper section filter element with clean tap water. At the same time, an unused toothbrush can be used to scrub the surface of the filter element.
2, the upper section of the filter element is filled with about half a pot of tap water, up and down vigorously shake the water purifier filter element several times, and then all the remaining water is poured away, so that the filter element micropores are smooth.
3. Fill the filter element of the water purifier with tap water, pat the mouth flat with your hand to make it vibrate, and then clean the filter material with tap water, repeat several times, until the water flowing out of the filter element is relatively clean and clean.