Driving recorder to change the usb head method:
< br >
The original plug of the driving recorder will be cut down, there will be two red and black lines, generally there will be four red, white, green and black lines on the USB, as long as the red and black two lines can be connected.
< br >
In fact, the most important thing to install the driving recorder is the line, the driving recorder power cord along the ceiling side and the glass intersect, then to the A column, and then the door frame seal, the bottom of the storage box, along the side into the gap, and finally inserted into the usb interface. In addition, it is also necessary to pay attention to the installation, in the driving recorder USB interface to reserve some length, to buffer, after all, the vehicle running on the road will inevitably have bumps, if the line is pulled too tight, prone to failure.
Driving recorder line to change the usb head method:
1. Prepare tools: a usb cable, wire strippers, scissors
2. Cut off the end of the car recorder connected to the cigarette lighter with scissors;
3, also cut the usb data with scissors, leaving the big end;
4. Use a wire stripper to peel off both ends of the red and black wires, and at the same time peel off both ends of the red and black wires of the USB port, and connect them respectively.
5. Wrap with tape after connection.
6, the connected driving recorder usb plug into the cigarette lighter car charger or the car usb can be used.