The installation steps of the first on-site tachograph D261 are as follows:
1. Preparation: Ensure that the vehicle is turned off and in a safe state. Check whether the tachograph packaging box contains the following items: tachograph host, suction cup, bracket, car charger cable, manual, etc.
2. Select the installation position: the tachograph can be installed in the front windshield, near the rearview mirror and other positions. It is recommended to choose a position with a good line of sight, avoid direct sunlight and do not affect the driving line of sight.
3. Install the support: Install the suction cup on the support to ensure that the suction cup is firmly secured. Adjust the bracket to the right Angle to capture the picture in front of the vehicle.
4. Wiring: Connect one end of the car charging line to the charging interface of the driving recorder host, and connect the other end to the cigarette lighter interface of the vehicle. Note: Make sure the vehicle is turned off and do this while the vehicle is powered on.
5. Install the tachograph host: Install the suction cup on the tachograph host in the selected installation position to ensure that the suction cup is firm. Then fix the support on the driving recorder host with the support adjusting screw, adjust the Angle of the support, so that the shooting picture meets your needs.
6. Power-on test: start the vehicle and observe whether the tachograph works normally. Check if the picture is clear and the Angle is appropriate. The Angle and position of the support can be further adjusted if necessary.
7. Set parameters: According to your needs and instructions in the instructions, set the relevant parameters of the driving recorder, such as recording time, video quality, etc.
After installation, please ensure that the tachograph is firmly fixed to avoid accidents during driving. At the same time, check the working status of the driving recorder regularly to ensure its normal operation.