KND NC tool setting steps
Step 1: Check whether the tool needs to be changed. 1. In DI mode, enter the tool change command T0x0x 2. In DI mode, input speed instruction: Sxxx0x Step 2: test cutting 1. Quickly approach the workpiece, taking care not to touch the workpiece.
2. Z-direction tool: in the manual feed mode, cut the workpiece end face until the end face is flat.
3. Do not move the Z-axis at this time, press ENU OFSET, switch to GEOETRY screen, confirm the tool number, input Z0.4. X direction tool: in the manual feed mode, cut the outer circle of the workpiece until the outer circle is smooth. Stop the spindle rotation, carry out the outer circle measurement, and record the outer circle diameter measurement value.
5. Do not move the X-axis at this time, press ENU OFSET, switch to GEOETRY screen, confirm knife number, and input X???? . (????) The number is the outer circle diameter value)
6. Enter other tool parameters, including tip radius (Rxx) and tip imaginary position (Tx). 7. Move the tool away from the workpiece until it is safe. The first knife to knife ends
operation is as follows
< br >
1. Turn the spindle and use the turning tool to turn the workpiece 360 degrees.
< br >
2. The X-axis coordinates cannot be moved during the Z-axis when the tool is withdrawn.
< br >
3. Measure the current size of the workpiece with a measuring tool.
< br >
4. Then press the knife on the system operation panel to make the system display 001002003.... Then scroll down to 101... Let's wait.
< br >
5, the system seems to appear below the measurement of two words, this time the value of the previous measurement directly input into the corresponding knife number on the line.
< br >
6, for example, the value of the previous measurement is the number one cutter, which is written in the position of 101 and other cutter positions on the knife and so on.
< br >
7, Measure the obtained value, press the program key to select the input mode to find the MDI page.
< br >
< br >
9, and then press start on it, the Z axis is relatively simple and many are generally on the zero.
< br >
10, directly move the tip of the knife to the position of the zero to be set, and then follow the steps on the line.