The toilet flushes the tank with 10 to 20 kilograms of water at a time.
This situation should be adjusted according to individual needs, big waste, small wash not clean.
Generally, the toilet flushes the water tank with 10 to 20 kilograms of water at a time.
The size of the toilet tank is not the same, the amount of flushing the toilet is not the same, but in any case, it is necessary to save water, water-saving skills, put stones and plastic bottles in the water tank and put water in the water tank so that you can save water, so that you can save a lot of water in a year. But be careful not to run water, running water that water can not be measured. So a box of flush toilet water is an average of 15 pounds.
A: Specific consideration should be given to the conditions of the installation site, household water requirements and other factors. Of course, it is best to choose the appropriate specifications of the water tank, choose the appropriate capacity. Generally speaking, a tank of about 100-150 liters is appropriate, so that it can make full use of its water surface area to absorb heat and quickly supplement the water supply; In addition, the volume of the water tank should not be too small, and it must be selected in combination with the actual situation of the installation site to ensure that the capacity is sufficient for use. In short, the appropriate water consumption of the tank should be selected according to the actual application and demand.
The water consumption of the flushing tank should be selected according to the actual situation. In some cases, in order to save water, you can choose a smaller water consumption flush tank. However, if the water consumption of the flushing tank is too small, it may lead to insufficient flushing strength, unable to flush the dirt, affecting hygiene and health. Therefore, it is necessary to choose according to the actual situation in order to achieve a balance between water conservation and hygiene effects.
Open the toilet cover, there are two buttons on the water tank cover, one is a small amount of water, the other is a large amount of water, the toilet tank is generally the general rule is less and less, want to full drainage and semi-drainage water output is the largest, the two buttons to the bottom on the line, full drainage should be adjusted to the bottom, because the full drainage is generally used for stool, the greater the water the better. The semi-drained urine is used for flushing, which generally does not need to use too much water, so it is appropriate to adjust to the middle position.
The water consumption of the water tank is good, and the water quantity is clean.