中文English
c无线充方案ichaiyang 2024-05-13 2:14 27
When the ETC is out of power, you can charge it with solar panels. The details are as follows:For solar ETC devices, the vehicle can be driven to the bottom of the sun for a few ho...

How to charge with data cable ETC?

When the ETC is out of power, you can charge it with solar panels. The details are as follows:

< br >

For solar ETC devices, the vehicle can be driven to the bottom of the sun for a few hours to charge the device. For ETC devices that do not have solar charging panels, you can plug in a dedicated power cord and charge with the help of a cigarette lighter jack.

< br >

If the internal battery is at the end of its service life, how to charge it can not be charged, you can only plug it in and use it, and the ETC electronic tag may also cause ETC failure. At this time, it is recommended to go to the ETC branch or the ETC service branch for testing, and the quality problems existing within the warranty period of 2 years can be replaced free of charge.

< br >

economic benefit

< br >

According to the data of the Ministry of Transport, it is expected that by the end of 2020, the national car ownership will reach 200 million, and the highway traffic mileage will reach 160,000 kilometers. It is expected that about 7,500 toll stations will be built. According to the planning of four toll lanes, two into and two out of each toll station, 30,000 ETC lanes need to be built.

< br >

Relevant analysis pointed out that if the 5.8GHzETC technology is fully built, the total investment in ETC lane construction will reach 9 to 12 billion yuan according to the construction cost of 300,000 to 400,000 yuan per lane. If each OBU (electronic tag) is calculated at 300 yuan, the total OBU investment is about 60 billion yuan.


ETC can be charged using a USB charger. First, fix the ETC on the car glass, and then connect the USB cable of etc to the charging interface of etc. After the connection is complete, plug the charger into the USB power supply of the vehicle.

< br >

The specific steps are as follows:

< br >

1. First, fix ETC on the car glass.

< br >

2. After fixing, connect the USB cable of etc to the charging port of etc.

< br >

3, and then hide the etc charging cable into the gap in the car.

< br >

4. Finally, plug the charger into the USB power supply of the vehicle.


After the device is out of power, it can be charged with the data cable normally, and the charger of the mobile phone can also supply power to the device if the rated power is relatively small, but it is best to use the original charging equipment.

< br >

Generally Etc devices have solar charging panels, so we do not have to worry about the etc device out of power so that it can not be used.



ETC does not need to be charged, it is powered by solar energy.