When the command is lost when the Panasonic welding robot is tracking, the following methods can be used to recover it:
Check the network connection: Ensure that the network connection between the robot controller and the computer is normal. If the network connection is unstable or interrupted, commands may be lost.
Restart the robot controller: By restarting the robot controller, you can clear possible temporary faults or errors and re-establish a communication connection to the computer.
Check the robot software version: Ensure that the robot software version is compatible with the computer software version and has been installed and configured correctly.
Restore default Settings: If none of the above methods work, consider restoring the robot to the factory default Settings. This usually resolves software errors or configuration issues.
Contact technical support: If the above methods do not solve the problem, it is recommended to contact Panasonic welding robot technical support for professional troubleshooting and recovery advice.
Please note that before performing any recovery operations, it is important to back up important data in the robot controller in case of data loss. At the same time, when dealing with robot failures, be sure to operate carefully to avoid further damage to the robot or injury to personnel.