To remove the rear wheel bearings of the 05 Mitsubishi Outlander, you first need to lift and stabilize the vehicle on the bracket. Then, remove the tire and brake assembly so that the bearings can be accessed.
Next, use an appropriate tool, such as a bearing extractor, to remove the bearing from the hub. Be careful not to damage the hub or bearing during disassembly.
After the removal is complete, the wheels and bearings can be cleaned and inspected to ensure that they are not damaged or worn. Finally, new bearings are installed and the brake assembly and tires are re-installed. Ensure that the vehicle manufacturer's guidelines and safe operating procedures are followed throughout the process.
05 Outlander four-wheel drive rear wheel bearing disassembly method is as follows
< br >
1. First, use the clip to jam the official roulette wheel to prevent the official roulette wheel from being jammed and unable to adjust after the piston springs back.
< br >
2, then use a wrench to loosen the screws on the timing wheel to facilitate fine tuning of the timing wheel.
< br >
3, then the top of the timing wheel is loosened, so that you can start proofreading.
< br >
4. When proofreading, first find the tooth shaft with color.
< br >
5, the color of the tooth shaft aligned with the small round hole on the wheel, so that the timing correction is completed.
< br >
6. Finally, release the clip and complete the correction
The steps to remove the rear wheel bearings of the 05 Mitsubishi Outlander are as follows: First, remove the wheel, then remove the brake disc and brake caliper. Loosen the hub bolt to separate the hub from the axle.
Using special tools, gently remove the hub from the axle.
Then remove the wheel bearing using a suitable axle wrench or thrust tool. Note the position and orientation of each bearing for reinstallation.