The charging head of the 11-generation hybrid Accord is installed on the inside of the left rear wheel arch. To remove the charging head, follow the following steps:
< br >
1. First, turn off the vehicle and unplug the charger.
< br >
2. Open the left rear door and locate the charging port cover on the inside of the wheel arch. Use your finger or coin to gently press down on the center of the lid, then turn the lid to the left until the lid is completely loosened.
< br >
3. Insert the charger. One end of the charging head should be aligned with the charging port and then inserted. It needs to be inserted with slight force until the charging head is stuck and can no longer be pushed forward.
< br >
4. Remove the charging head. After charging, you need to press the button on the charging head first, and then gently pull out the charging head.
< br >
5. Close the charging port cover. Insert the charging port cover into the charging port, then turn the cover to the right until the cover snaps and closes.
< br >
It should be noted that before removing the charging head, be sure that the charger has been completely removed and the button on the charging head has been pressed to avoid accidental injury or damage to the charging system.
First turn off the charging gun. Some charging guns will be powered off by swiping the card, scanning the bar code, entering the password, and unplugging the power supply. After the power is off, please wait for a moment and then pull the charging gun out of the car jack. When the new energy vehicle is not fully charged, it must pay attention to safety. After the power failure do not directly unplug, wait for a while. Before charging, it is necessary to confirm whether the car is in good condition and whether the charging device is normal. After charging, before leaving the site, ensure that the voltage and current are within the normal range. If necessary, check the charging status regularly.