To use the Univ Sport wireless charging feature, you need to complete the following steps:
< br >
1. Make sure your Univ Sports headset is connected to your phone or other device and that there is enough power in the charging case.
< br >
2. Connect the charging case to a USB plug or other compatible charging device and charge it until it is full.
< br >
3. Put the Univ Sport headphones back in the charging case, making sure they are properly placed on the contact point for charging. Check that the LED light is on to indicate charging.
< br >
4. When you need to wireless charge the headset, please place the charging box on an appliance that supports Qi standard wireless charging (such as a wireless charging board), and then wait for some time. If everything is normal, the light will turn red, indicating that wireless charging is underway.
< br >
5. When the Univ Sports headset is fully charged, the LED indicator will turn green. At this point you can take out your headphones and start using them.
< br >
It is important to note that before using wireless charging, make sure that your phone or other device supports Qi standard wireless charging and is in the correct position (usually referring to the close contact between the back of the phone and the wireless charging support surface).
The following steps are required to use univ Sport wireless charging:
1. Confirm that the phone supports Qi standard wireless charging or use a wireless charging receiver.
2. Turn on the wireless charging function of the phone. 3. Contact the back of the phone with the wireless charger to ensure that it can be charged.
4. Wait for the phone to charge.
Extension:
1. If you use a wireless charging receiver, you need to place the receiver on the back of the phone, and then contact the wireless charger with the receiver.
2. Ensure that the wireless charger has sufficient power when using, otherwise it cannot charge the mobile phone normally. 3. The wireless charger has a certain magnetic force, and you need to be careful to prevent the phone from slipping or wearing the back of the phone when using it.
First, the wireless charger on the vehicle is fixed in the appropriate position in the cab, and the data cable connector of the wireless charger is connected to the cigarette lighter interface of the car, and the other end is connected to the wireless charger.
After fixing the wireless charger, make sure that the wireless charger will not slip off and that the wireless charger can be used normally.