If you want to remove these very strong, the fixing tape can be heated with the hot air of the hair dryer, and when the fixing glue is softened, we can easily tear it off the wall.
When we buy fixed stickers, we can check its information and try to buy fixed stickers that are easier to tear and will not cause damage to the wall, so that we will not encounter the situation that fixed stickers cannot be removed.
You can remove the non-slip tape in the following two ways.
Method 1: Use alcohol or gasoline, drop it on the edge of the non-slip sticker, and tear it off forcefully after the liquid is soaked.
Method 2: Soak the non-slip sticker in hot water for a period of time, and then slowly tear it off after the viscosity is weakened.
Anti-slip stickers are products made to improve safety performance, and should be taken off carefully to avoid damage to furniture or the floor.
It can be removed by the following methods :1, with a glue remover.
Buy the glue remover directly apply or spray on the offset print on the sheet, after more than ten minutes, with a clean rag to wipe the offset print is gone.
2. Medical alcohol can be used. Apply alcohol to the offset on the sheet, after more than ten minutes, rub with your hand for a while to remove the offset. Either way, the offset print can be removed.
Gently open with a knife, and then slowly tear it off, which can play a certain isolation role, can be taken down well, and it is smooth and delicate to use
First, turn it upside down and remove the non-slip tape at the bottom One thing to note here is that each sticker place has a preset opening, so that you can easily tear off the sticker, just the gap of the long strip, can be torn out at once, it is a careful design ~ if you plan to put them back, then be sure to tear from the gap, otherwise it will be torn at once After tearing it open, we can see the screws hidden inside