1, first draw the shape of what we need to carve, and then process it, as follows:
< br \/ >
< br \/ >
< br \/ >
2, select the graphics we need to process, we find the tool path in the toolbar, find the area engraving. (Be sure to select the graphic)
< br \/ >
< br \/ >
< br \/ >
3, after coming in, we set the tool, select the required tool, and the depth of our engraving, can not be changed after finishing, so every time to do well, otherwise to do from.
< br \/ >
< br \/ >
< br \/ >
4, when walking the knife, there will be some edge not carved to, so there is an overlapping place to set, you can mill off.
< br \/ >
< br \/ >
< br \/ >
5, fine carving and rough carving are the same in some times need to be used.
< br \/ >
< br \/ >
< br \/ >
6, finished is the following, the five-pointed star will not be milling, it stands out.
< br \/ >
< br \/ >
< br \/ >
7, if there are graphics inside will be milling inside, is separated by a region. So you can make an analogy.
When the road strength is set, the depth of the knife is set layered, such as the carving depth of 3mm, then the depth of the knife is set 1mm when the generating path will be generated on Z to generate 3, and the knife will go three times each time 1mm.