Use the original charger to enable fast charging
< br >
R9000P fast charge is PD1.2 fast charge protocol, and the rear side TYPE-C supports PD 100W fast charge: the startup charging supports 65W gear, the shutdown charging supports 45W gear, and the PD charging only supports balanced & Quiet mode, Beast mode is not supported. Savior r9000p charging method with pd:
< br >
1, for the new notebook just bought back, due to the manufacturer's test after the first charge, so the first boot battery should have 3% of the power, at this time do not immediately use the external power supply, but the remaining 3% of the power used up until the shutdown, and then use the external power supply to charge.
< br >
2, do not turn on when charging, charging time must be more than 12 hours, until full. After a full charge, unplug the power adapter, and then charge the battery once and again, repeated three times in order to activate the maximum potential of the battery.
< br >
3, in daily use, you should try to reduce the number of times to use the battery, because the number of charge and discharge of the laptop battery is limited, each charge, the battery life is reduced once, so if you use the external power supply, the battery should be taken off.
< br >
If you often plug and unplug the power several times a day, and the notebook is equipped with a battery, the damage to the battery is greater, because each external power access is equivalent to charging the battery once.
< br >
4, the laptop battery generally has a memory effect, partial charging (less than 100%) will lead to the chemical performance of the battery cell is inconsistent, so that the battery performance will decline, so be sure to use up the power and then charge (less than 1%), which is the best way to avoid the memory effect, otherwise the battery is easy to temporarily lose power supply ability.
The R9000P PD Fast Charge is a charger with fast charging function. First, make sure the connection between the charger and the device is good.
Next, plug the charger into the power supply and connect the charger to the device you want to charge using the appropriate Type-C cable.
After confirming that the connection is correct, turn on the power switch and the charger will start to provide fast charging for the device.
At this point, the battery indicator of the device will show the charging status. After a period of time, the battery of the device will be fully charged. To ensure safety, it is recommended to avoid answering the phone or using the device while charging. In addition, when using the R9000P PD fast charge, be sure to refer to the instructions of the relevant equipment to avoid any accidents.
R9000P supports 100w PD charging, 100w run is not satisfied with the performance of this game.
< br \/ >
The R9000P has three power consumption modes: Silent mode, Balance mode, and Beast mode. 100w PD can only maintain silent mode, suitable for office low-key touch fish. If you need to play large games, the original 300w large board brick is irreplaceable