Pull the drawer down at the end and lift it up to open it. Although the freezer drawer is a split design, it can only be cleaned as a whole when cleaning, and cannot be separated.
The transparent and opaque parts are made of PS plastic, not glass. This design is currently the most backward in the industry, the water is easy to smell, and remember to choose an integrated molding drawer when buying a refrigerator in the future.
Extended information:
Haier refrigerator drawer transparent cover removal steps
The transparent cover on the drawer box of Haier refrigerator can be broken down and cleaned directly through relevant tools.
the specific contents are as follows
1. The transparent cover is hooked by a total of 5 backbuttons, two on the left and right sides respectively, and three below.
2. The reverse buckle is long on the drawer body, and the corresponding opening on the transparent cover hooks the reverse buckle. The transparent cover is combined with the drawer body in a concave shape, resulting in almost no movement of the drawer body in the reverse part.
3. To open it, you can only pry it from the reverse opening of the transparent cover with a knife. The material of the transparent cover belongs to hard plastic, which is very brittle, especially easy to break, and it is very difficult to pry open.
4. You must pry open all 5 backsnaps to pull out the transparent cover.
The transparent disassembly method of refrigerator freezer storage box is as follows
All the drawers in the refrigerator can be removed, and it can be cleaned directly. Each drawer of the refrigerator freezer room is pulled out first, and when it is near the end, it can be easily removed by lifting the drawer handle slightly upward. The box at the bottom of the freezer can usually be drawn horizontally.
< br >
1, do not use a hard brush, wire brush, abrasive (such as toothpaste, detergent powder, etc.), organic solvents (such as gasoline, banana water, acetone, etc.), acid and alkaline substances to clean the refrigerator drawer.
< br >
2, the various cracks of the refrigerator drawer, corners, injection molding holes left during injection molding, the interior of the handle and other parts are dirty places that remain more, and should be cleaned.
< br >
3, after cleaning should be dried water and then put back in the refrigerator, to prevent too much water into the refrigerator, resulting in frost in the refrigerator.