The water column on the automatic filling kettle is disassembled as follows:
1. First, disconnect the power supply to ensure safety.
2. Remove the lid and observe the connection mode of water column. In general, the water column is connected to the pot body through a spiral interface.
3. Use a proper screwdriver or other tool to loosen the screw connector. Be careful not to exert too much force to avoid damaging other parts of the kettle.
4. When the screw connector is loose, gently remove the water column. If the water column is difficult to pull out, try soaking the water column with some warm water or vinegar to loosen the joint.
5. After the water column is completely removed, check whether there is damage or foreign matter inside the kettle. If yes, clean or replace the components in time.
6. Install the new water column on the pot body, align it with the spiral interface, and ensure that the connection is tight.
7. Cover the kettle again, turn on the power supply, and test whether the automatic water filling function is normal.
Throughout the process, be sure to operate with care so as not to damage other parts of the automatic filling kettle. If necessary, you can refer to the product manual or seek professional help.