1. First, press the protruding button on the head of the shaver to pop out the top cover, as shown in the picture.
2. After the top cover is loosened, separate the top cover from the razor body, and then brush off the debris in the part connecting the main body and the top cover with the attached small brush.
3. After the main body is cleaned, rotate the small triangle in the middle of the top cover in the direction indicated so as to separate the tool holder guard from the tool head.
4. After separating the tool holder cover, clean the tool holder cover with a small brush.
5, after the tool holder cover is taken out, because there is nothing to hold it, the tool head can be easily taken out.
6. After the knife head is taken out, take the blade blade out of the knife head cover, and clean the blade blade and the knife head cover respectively.
7. After all the parts are cleaned up, install each part back respectively in the opposite order as disassembled.
8, finally the top cover part and the main part of the razor can be reconnected.
Shaver disassembly steps are as follows:
1, use a screwdriver to remove the outer decorative shell, there is a layer of translucent plastic shell inside, can be directly removed, as shown in the picture.
2, the motor shaft has two screw holes, but only one screw is outside. The transmission gear is first fixed with the motor during assembly and then sealed with glue. To screw on this screw, you need to break the glue, as shown in the figure.
3, In this Angle can clearly see the push scissors, push the black switch next to it, can control its opening and closing, as shown in the figure.
1, before starting to disassemble, first take down the electric knife head and the like; In fact, it's not too important, just looks more comfortable. It's actually important to find where the razor screws are. Generally speaking, the first screw is very obvious, and the second screw is very hidden, as shown in the right part of the picture, such a deep peekaboo technique I believe you can appreciate.
2, Jobs, I'm not afraid of people trying to break the shell into serious injuries. Because the quality of the shell is generally really difficult to be seriously injured by everyone. I do not want everyone to just vigorously open the fallen parts or forget the installation sequence of the parts. Never \"Tai Chi\" slow. After all, the purpose of disassembly is to install and restore. And then everyone can see screw kill screw.
3, although the motor is small, it drives the quality of dad's life. Because the shaver does not work, it is usually the reason for the small motor or the rechargeable battery inside, and the battery can be easily charged. As you can see, the Pony's link is down, so maybe the problem is the Pony.
Then we used the old method, holding a lighter in one hand and a small pair of scissors in the other, alternating between each other, leaving the inner core of the wire bare until it could be reconnected. Manually press the motor control switch, find the motor rotation, done.
4. Jobs finished the assembly in the original order. At this point, dad's electric razor was well-collected by the junk drawer of the big mouth, enjoying the years, and died.
< br \/ >