Specific disassembly and cleaning methods:
1, removal and cleaning method of dust collection cup: First of all, you need to press the dust removal switch of the dust collection cup to clean up the dust and debris in the cup (it is best to use a garbage bag to catch the falling dust below to avoid secondary pollution of the environment). Then press the switch down, at this time you can directly separate the dust collection cup and the body, use the brush to clean the yarn and dust attached to the body (do not use water), rinse the dust collection cup with water and dry it, and then put it back after drying.
2, drum suction head\/filter removal cleaning method: the suction head is placed upside down, and the rotary plastic sheet attached to the vacuum cleaner is used to rotate out the drum core in the jack on the side of the suction head. Then clean up the winding debris on the drum core, clean the drum core with water and put it back. The method of removing the filter is simpler, the filter can be removed by rotating the filter switch at the head of the fuselage, and the filter can be washed with water.
1. Cleaning is provided with two bayonets on the suction head, which can be opened with coins, usually the large bayonet can be taken out of the rolling brush to clean the hair inside, while the small bayonet can be removed and cleaned with water.
2. Remove screws Remove all screws from the body of the suction head using a screwdriver.
3. Take out the transparent cover and gently open both sides, take out the transparent cover, and remove the motor protective cover.
Remove the dust collection cylinder first, just press down with two thumbs to open the red mechanism on the bottom cover of the dust collection cylinder, press until the end, the cylinder will pop out, and then clean up the floating ash with a toothbrush.