1, hot and humid towel treatment, ten minutes after the curing of the universal adhesive soft can be removed. Put a drop of glue on the place where there is glue, and the cured glue becomes soft and can be removed with a towel.
2, organic solvent dissolution, such as acetone. Clean with a gel remover.
3, if the conditions are limited, you can use alcohol (liquor, cooking wine, etc.) to soak the sticky place for 1-2 minutes, and scrape it off slowly with scissors (careful paddling).
4, buy a bottle of \"God water\" or \"turpentine\
5, use banana water droplets on the glue stains, and then use an old toothbrush to constantly stir the brush, until the glue stains become soft after taking off, and then rinse with clean water, repeatedly scouring, brush clean can be stopped.
6. Use insulating oil. Pour the insulating oil inside the transformer on the glue stain, and the universal glue will soon become soft and can be easily rubbed off.
7, a small area is glued to the universal glue, as long as it is soaked in hot water; Assume that a large area is covered with universal adhesive, coated with acetone, and it can be removed for about 5-10 minutes.
8, with vinegar, peanut oil or salad oil can eradicate all-purpose glue, with nail polish remover can also. Because glue is made of the same stuff as nail polish. Before using the glue, you can apply some grease on your fingers, such as skin cream, hand cream will not stick to your hands. Extended information: Multipurpose glue should be stored in a cool, dry place and away from children. Do not let the direct sunlight, the temperature is too high, the sealing is not good or the exposure time is long, the solvent volatilization will cause the viscosity is too large, can not be constructed. Can be used toluene, ethyl acetate, butanone or acetone or dilute, can be stirred evenly continue to use. The adhesive strength is large, the adhesive must look at the timing, the one-time alignment of the position bonding, can not move back and forth. After bonding, the air is driven away by pressing, hammering or rolling to compact the adhesive layer and improve the bonding quality.