1. Find the joint of the head of the shower head (where there is a rubber ring) and pry it open with a flat-mouth screwdriver while spinning. The bond is on the edge, the metal is prone to rust, and can be opened with a rust remover.
< br >
2, there is a shower head in the middle, fixed with bolts, the bolt cap has a sheath, with a knife can be picked down.
< br >
3, the shower is blocked by water and alkali, you can directly remove the scale without disassembling: the nozzle is taken apart in vinegar, soaked for about one and a half hours, and the rust and scale are gently brushed with a brush.
< br >
4, every half a year or less, remove the shower and put it in a small basin, irrigate the surface and interior of the shower with edible white vinegar and soak for 4-6 hours, and then gently wipe the water nozzle on the surface of the shower with a cotton rag: reinstall the joint and drain the water for a moment, until the white vinegar and scale flow out with the water, which can eliminate or reduce the influence of scale on the shower and can take a certain bactericidal effect.
Prepare the tools needed for cleaning: screwdriver, paring knife and shower head to be removed.
two
\/ 6
Use the sharp end of the paring knife to jam the innermost circle of the shower head and pry it open.
three
\/ 6
Then you can see a screw, turn the screwdriver towards the screw.
four
\/ 6
After the screw is rotated out, you can take out the top shell.
five
\/ 6
After the screw is removed, the plastic round plate can be taken off and cleaned directly
six
\/ 6
You can put rice vinegar in it, and then let the nozzle of the nozzle down in the rice vinegar, about three or four hours, you can take it out, and then open the water, the scale will be flushed out.
You can remove it and prick it one by one with a fine needle, so that it is transparent, or you can soak the shower head in water with vinegar, or citric acid water, so that the acid-base reaction, the scale will melt