Rabbit charging does not go into the electricity, there may be the following reasons:
< br >
1. Charger problem: It may be that the charger is faulty, damaged or the line is disconnected, resulting in failure to charge the meter rabbit. Try replacing a charging cable or plugging it back in.
< br >
2. Battery aging: If the rabbit has been used for a period of time, and the battery has been aging, it will also lead to no charging or insufficient power after charging. The battery needs to be replaced.
< br >
3. Foreign bodies enter the charging hole: If there is dust, foreign bodies or external damage in the charging hole, the charging hole cannot work normally, it will also lead to the normal charging of the rabbit. Professional cleaning tools or soft brush can be used to clean or salvage.
< br >
4. Charging protection mechanism: Some electronic products will automatically control after being fully charged, cut off the power supply to avoid excessive current, and then plug in the charger for charging after a certain period of time.
< br >
If the above methods cannot solve the problem, it is recommended to contact the after-sales service department of Mito, so that professionals can repair or replace the parts.
one
Check the adapter and watch charging interface for foreign matter blockage, mildew, corrosion, internal connection cable damage, etc., if there are such phenomena, go to the nearby customer service center for cleaning and testing.
two
If the meter phone watch is not used for a long time, or the watch is not charged in time after the low power shutdown, the watch battery has excessive discharge, need to connect the charger and wait for a period of time, such as failure to turn on the need to go to the nearby customer service center for cleaning and testing.
1, it may be that the rice grain and the charging slot are not tightly inserted, which is the most common reason for non-reaction of charging;
< br >
2, the metal charging joint of the rice grain is oxidized, resulting in no charging;
< br >
3, gently scrape the metal joint with a small blade, and then try to charge.
1, the connector of the charger is loose, it is likely to lead to the toothbrush can not be charged, which is also a common problem, it is recommended to check when charging to see if the connection is normal.
< br >
2, put the toothbrush on the charging pile, long press the switch key for 10-15 seconds, wait until the light is not bright, take the toothbrush away from the charging pile, and then press the switch key to force restart
Methods\/steps\/Answers:
< br >
1, first confirm whether the data line is normal, the data line looks normal on the outside, but it may have been broken inside;
< br >
2, the battery is too low battery protection, will lead to the battery into a dormant state, need to charge 20-30 minutes to activate the battery can continue to charge;
< br >
3, battery or equipment hardware failure caused, to after-sales or store inspection and maintenance
hi
You may have entered fastboot mode by mistake, but you can exit it by holding down the power button for a long time.