Wireless charging may be broken for the following reasons:
< br >
1. Hardware failure: If your device cannot be charged, it may be that the wireless charging chip or other hardware components are faulty.
< br >
2. Use problems: In some cases, wireless charging will be damaged due to improper use or accidental fall, such as dropping the wireless charger to the ground during the connection process.
< br >
3. Software issues: Although relatively rare, there are sometimes some software-related issues, in which case the device may exhibit a range of abnormal behaviors related to the inability to charge.
< br >
4. Environmental problems: Long-term use of equipment in harsh environments such as humidity, high temperature and low temperature will also lead to problems in the process of wireless charging.
< br >
If your device is unable to charge, it is recommended to check whether it is due to a device failure. If it is the hardware part of the problem, you need to contact after-sales maintenance service to repair or replace; If it is the use of the problem, you need to pay attention to improve their use of habits; If it is a software problem, you can try to upgrade your system version or reset your device Settings to eliminate the impact. In addition, during normal use, do not put the mobile phone in an overheated or too cold environment to minimize the adverse impact on mobile phones and other devices.
The reasons why wireless charging is broken may include the following:
< br >
1. Charger failure: The process of wireless charging requires a set of chargers and charging boards, if the charger is damaged, it will affect the normal charging of the entire system.
< br >
2. Charging is not set correctly: In order for wireless charging to work properly, it is necessary to place the charging board on the charger, within the correct charging range, and put the device that needs to be charged on the charging board, sometimes if the position is not correct, it may cause the charging board to not operate normally.
< br >
3. Power failure: No power supply or power failure will lead to charging failure, check whether the charger is plugged in properly or whether the charging board is damaged.
< br >
4. Equipment failure: If the equipment that needs wireless charging fails, such as battery damage, receiver failure, etc., wireless charging may fail.
< br >
5. Other unknown reasons: Because wireless charging technology is relatively new, sometimes there will be some unknown faults, such as firmware update problems, can not detect the receiving device, etc., need to be investigated according to the specific situation.
It may be that the mobile phone protective case is too thick, it is recommended to choose a thin mobile phone protective case or not use when using wireless charging; It may be that the phone is not aligned with the charging area of the wireless charger, it is recommended to check the wireless charger specification to determine the wireless charging area; It may be that the wireless charger is not suitable for the wireless charging system of the mobile phone. It is recommended to use the charger that meets the wireless charging requirements of the mobile phone. May be the wireless charger failure, it is recommended to contact after-sales maintenance. The details are as follows:
< br >
1, the phone case is too thick will affect the mobile phone charging coil and wireless charger induction, resulting in normal charging. Therefore, it is recommended to remove the protective case of the mobile phone before using the wireless charger to charge;
< br >
2, the charging coil area in the mobile phone is small, if the use of wireless charging when the mobile phone is placed incorrectly will also lead to normal charging;
< br >
3, may be wireless charger and mobile phone wireless charging system is not suitable, it is recommended to use mobile phone wireless charging requirements of the charger;
< br >
4. If the above situation is excluded, it may be that the mobile phone wireless charging module or wireless charger fails, and it is necessary to go to the after-sales point for detection and processing.
It could be that the motherboard is damaged and needs to be repaired