Not set up, the wireless router connects to the wireless router, the second router is set up, there are two ways (provided that the first router has been set up) :
The first method: dynamic ip mode (the first route is the primary route, the second route is the secondary route)
1. Plug in the secondary router, do not connect to the main routing lan port, and reset the secondary router (restore factory defaults);
2, the computer connects to any lan from the router
mouth
The Settings page is displayed.
3, according to dynamic i
p mode setting;
4, and then set the ssid, encryption and password;
5. Save and restart;
6. After setting up, route the main lan
The network cable is connected to the wan port of the secondary router.
The second method: wireless ap mode
1, first connect the computer to the lan port of the secondary router, and change the ip address of the secondary route. For example, most router addresses are 192.168.1.1, we just need to change the router ip address to 192.168.1.10;
2. Turn off the dhcp function of the secondary router in the Settings;
3. Finally, connect the network cable from the main router to the lan port of the secondary router (any one will do), note that it cannot be the wan port.
There may be a problem with the secondary router Settings. [Method] Check the Settings of the secondary router. When setting up the wireless bridge, there are two places in the secondary router that need to be noted:
1. Change the IP address of the LAN port. The IP address of the secondary router must be in the same network segment as that of the primary router. The ip address cannot be the same as the ip address of the primary router. Otherwise, IP address conflicts may occur.
2. If the IP address of the primary router is 192.168.0.1; The ip address of the secondary router must be an ip address in the range 192.168.0.2 to 192.168.0.254. If the IP address of the primary router is 192.168.1.1; The ip address of the secondary router must be an ip address in the range 192.168.1.2 to 192.168.1.254.
There are two ways to do this.
First: Unplug the power, stop for a while and then plug it in.
Second: Initialize the router and reset it.