a three-terminal voltage regulator parameter: Input voltage 15v. The current is 3A. The power is 600w. The maximum voltage is 12V. The model is ME6203 voltage regulator type.
Output A (pin 11) : Output A. Pins 11 and 14 are two complementary outputs. 1Ground (pin 12) : Signal ground. 1Vc (Pin 13) : Output stage bias voltage access terminal. 1Output B (pin 14) : Output B. Pins 14 and 11 are two complementary outputs.
SE8117TA is SAdjustable three-terminal regulator in OT-223 package with output current 1A, no different from LM317. The output voltage is calculated with the same formula as LM317, Vo=25* (1 R2/R1), where R2 is the lower half of the divider resistor and R1 is the upper half of the divider resistor.
The tube is not a voltage regulator diode, but a transient voltage suppressor diode, with a maximum clamping voltage of 414V, 600W. Play a surge voltage protection role, you can use the upper, lower gear, or varistor, substitute. Power supply voltage stable environment can also be used.
1, ①, about the above SC662C-3 chip belongs to low voltage differential regulator IC, S0T23-3 package, its parameter is 3 V /250mA. 2, about the above 1117-3 chip is also a low-voltage differential regulator IC, SOT-223 package, its parameters are: 3V/1000mA.
2, Snapdragon 665 and Snapdragon 660 both use the 8 core architecture of 4*Kryo260 big core and 4*Kryo small core, the difference is that the Snapdragon 665 big coreThe main frequency is 0Ghz, which is slightly lower than the 2Ghz of the Snapdragon 660, and other aspects are basically the same.
3, the voltage regulator chip 662K is a CMOS step-down voltage regulator with high ripple rejection, low power consumption, low voltage difference, overcurrent and short circuit protection.
4, Asus B660M-K motherboard is a mid-range motherboard using Intel B660 chipset. This motherboard uses the standard Micro-ATX board type, which is 24×24cm in size and is suitable for use with mid-tower cases. The motherboard uses a black PCB with silver cooling armor design, the whole outside. Input voltage 230VAC ±15%, output power 60-70W; Input voltage 85-265VAC, output power 50-60W.
This is a low voltage differential linear regulator APL5611A in SOT23-6 package, which can drive an external n-channel MOSFET by using an adjustable output external resistance divider, integrating various functions, such as power-on reset (POR), VCC power supply to prevent voltage error operation, undervoltage function protection (UVP), etc.
Foot patch integrated ae935, screen printing for AE SOT23-6 package is a low-voltage differential linear voltage regulator LDO chip, the specific model is: RT9011, its typical application circuit is shown below.
Power supply regulator. Silk screen 58AC six-pin chip is a power regulator, the main function is to provide stable voltage to electronic devices. The chip has overheat protection function, which can monitor the chip temperature and automatically adjust the output voltage to prevent the chip from overheating damage.
This chip has NR (noise reduce) pins, is a low noise LDO chip, generally can not be replaced by ordinary LDO.