中文English
芯片烧录器ichaiyang 2024-05-10 8:00 55
The VISDA 100 programmer is a tool for programming electronic devices. To use the Wistad 100 programmer, you need to follow these steps:1. Preparation: Ensure that the power supply...

How to use Wistar 100 programmer?

The VISDA 100 programmer is a tool for programming electronic devices. To use the Wistad 100 programmer, you need to follow these steps:

1. Preparation: Ensure that the power supply of the programmer is connected, and start the software interface of the programmer.

2. Connect the device: Connect the chip or microcontroller you want to program to the programmer through the appropriate interface. This may involve plugging in adapters, sockets, or direct welding.

3. Select the chip: Select the chip model you want to program in the programmer software. If the programmer supports this model, the software loads the corresponding programming parameters.

4. Upload firmware: The firmware or program file to be burned to the chip is uploaded to the software of the programmer. This is usually done by clicking the \"Open\" or \"Upload\" button.

5. Set parameters: Set programming parameters as needed, such as erase chip, programming speed, voltage, etc.

6. Start programming: After confirming all Settings, click \"Start Programming\" or similar button to perform programming operations. The programmer erases old programs and burns new ones to the chip according to the parameters you set.

7. Verification results: After the programming is completed, you can use the verification function in the software to check whether the chip is successfully programmed, or by other means (such as testing the chip in the device) to confirm whether the programming is successful.

8. Disconnect: Once you confirm that the programming is successful, you can safely disconnect the chip from the programmer.

Please note that the specific steps may vary depending on the programmer type and software version. Therefore, it is best to consult the programmer's user manual or contact the manufacturer for detailed guidance before using it. In addition, a certain amount of technical knowledge and experience is required during the programming process, especially when dealing with complex chips or performing special programming tasks. If you are not familiar with these processes, you may need professional help.