Xugong CAN communication failure may be caused by the following reasons: interface line connection problems, interface chip failures, data transmission errors, signal interference, etc. The solution is as follows:
1. Check whether the cable connection of the CAN port is normal and ensure that the cable is in good contact without loosening or short circuit.
2. Check whether the CAN interface chip is damaged and replace it with a new chip.
3. Check whether there are errors in the CAN data transmission process, you can determine the problem by monitoring the received and sent data frames.
4. If you find that CAN communication is interfered with by signals, you can use shielding\/terminal resistors, filters and other devices to eliminate the interference.
5. Use professional CAN communication fault diagnosis tools for troubleshooting, such as CAN analyzer, fault diagnosis instrument and other equipment for detection and analysis.
In short, to solve the Xugong CAN communication fault, it is necessary to carefully check each link, find out the cause of the fault and carry out the corresponding repair and adjustment. If the above methods cannot solve the problem, you may need to contact Xugong after-sales service for further troubleshooting.
1. It can be solved.
2. XCMG can communication failure may be due to the following: a) hardware failure, such as loose or damaged cable; b) Software setting errors, such as incorrect parameter configuration; c) The communication module is faulty, such as the CAN chip is damaged.
3. To solve the can communication failure of XCMG, the following measures can be taken: a) Check whether the connection cable is firm and ensure that the connection is normal; b) Check the software Settings and confirm that the parameters are correctly configured; c) If the communication module fails, a new CAN chip or the entire communication module can be replaced.
In addition, you can also refer to the Xugong equipment manual or contact Xugong after-sales service department for more detailed solutions.