中文English
可编程时钟芯片ichaiyang 2024-05-10 5:18 53
Programmer 809H is a common single chip computer programmer, mainly used for 51 series single chip computer programming. Here are the steps to use:1. Download and install the USB d...

How to use Programmer 809H?

Programmer 809H is a common single chip computer programmer, mainly used for 51 series single chip computer programming. Here are the steps to use:

1. Download and install the USB driver from the official website.

2. Connect the programmer to the computer via USB cable, and the computer will automatically identify the device and install the corresponding driver.

3. Open programming software, such as keil or proteus.

4. Select the type of programmer used in the programming software as \"STC-ISP\" or \"USBISP\

5. Insert the microcontroller to be programmed and connect the programmer to the microcontroller.

6. In the programming software, set parameters such as the chip model and file path.

7. Click the \"Download\/Burn\" button and wait for the program to finish downloading.

8. After downloading, pull out the programmer and MCU.

It should be noted that the specific steps may vary depending on the programmer type and software version, and it is recommended to read the relevant documentation or instructions before operation.


A: The steps to use the programmer are as follows: Step 1: Insert the burned chip (such as BIOS) into the burned card in the correct direction (the wrench of the chip notch to the card).

Step 2: Insert the matching cable into the communication port of the serial port of the computer and the programmer.

Step 3: Turn on the power supply of the programmer (the power supply is 12V), and the light indicator of the power light tube in the middle is on, indicating that the power supply is normal.


The use of the programmer 809H requires the following steps: 1. Connect the programmer: connect the USB interface of the programmer to the computer, connect the power supply, and then insert the chip of the single-chip microcomputer to be burned into the programmer, and scan the model of the single-chip microcomputer through the programmer. 2. Download related software: Download the programming software and driver corresponding to the single chip microcomputer model on the computer, install it, and open the software.
3. Set parameters: In the programming software, select the program file that needs to be burned, and set the required parameters, such as protection options, clock frequency, etc.
4. Start burning: After setting all parameters, click the \"Burn\" button to start burning.
Overall, the programmer 809H is easy to use, requiring only a simple connection, download software, set parameters and burn to complete the operation.


The Programmer 809H can be used by the following steps: 1. Connect the programmer to the computer and insert the chip to be burned into the programmer slot.
2. Open the corresponding chip burning software, such as STC-ISP, 51 MCU burning device and so on.
3. Select the corresponding chip model and burning mode in the software, and load the program or firmware to be burned.
4. Click Start Burning and wait for the burning progress bar to complete.
5. After burning is complete, unplug the chip from the programmer and insert it into the target circuit board.
Because the programmer 809H can support the burning of a variety of chips, and most of the use methods are the same, if you have other questions or questions, you can check the specific programmer instruction manual, or consult a technical person.