After entering the car, close the door tightly until the top light is off. Turn on the ignition switch and the instrument light will come on. Quickly press the rear defrost switch 2~4 times, then the top light will come on. Press any remote control key twice in the 5 seconds that it lights up, and the match is over. Chinese car anti-theft lifting party preparation conditions: key with chip and 4-digit electronic password.
method
(1) KEY-ON, wait 4 seconds;
(2) Step on the throttle valve until it is fully open, and the light is off;
(3) Loosen the throttle to close;
(4) According to the first password, step down the throttle number is the same as the first password number;
(5) Repeat steps (2) to (4) to enter the second to fourth digit password;
(6) Step on the accelerator until the light comes on; Release the throttle light into a flashing state, then anti-theft lifted! If the engine anti-theft system itself fails, the electronic code on the emergency start card should be used to start the vehicle.
The user must keep the emergency card and memorize the electronic code on the card.
Emergency starting method: Turn the key from \"LOCK\" to \"ON\" → Wait for about 8 seconds → Hold the accelerator pedal until the engine fault indicator is off → (Press the accelerator pedal the same number of times as the first digit of the electronic code) → Hold the accelerator pedal until the engine fault indicator is on → (Press the accelerator pedal the same number of times as the second digit of the electronic code) → Hold the accelerator pedal until the engine indicator is on →... Step on the accelerator pedal for the fifth time and wait for the engine fault indicator to light up → Release until the flashing stops → Turn to \"START\" to start the engine.
(Note that the accelerator pedal should have a rhythm, and the step is not busy) If the process goes wrong, turn the key to \"LOCK\" and start again.
A match is required.
Because after the replacement of the car control module, the code of the original remote control key is different from that of the new control module, and it needs to be matched before it can be used.
At the same time, in the matching need to pay attention to the matching methods and steps, you can refer to the relevant car manual or consult professional auto repair personnel.
If the remote control key has not been correctly matched, it may also be the problem of the remote control key itself, which needs to be replaced or repaired, or the problem of the control module, which needs further detection and treatment.
When carrying out vehicle repair and maintenance, pay attention to choosing a regular 4S shop or a professional auto repair shop to avoid unnecessary trouble.
Match is required because after replacing the car control module, the corresponding remote control key no longer matches the old module, and you need to match it again to continue using it.
Matching steps: 1. Insert the key to open the door 2. Within 15 seconds, insert the key into the ignition slot and turn it on for 5 seconds, then turn it off for 5 seconds 3. Press the remote control button 3 times within 15 seconds 4. Wait for the remote control to lock and unlock twice 5. Test whether the remote control works properly.