The TDA7388 is a versatile audio amplifier that is widely used in audio equipment and automotive audio systems. To properly connect the TDA7388 power amplifier chip, follow these steps:
< br >
1. Prepare the device: Make sure you have the TDA7388 power amplifier chip, power filter capacitor, inductor, output coupling capacitor, input coupling capacitor, speaker and other necessary devices.
< br >
2. Power supply: Connect the power filter capacitor to the power pin of the TDA7388. Care is taken to ensure that the power filter capacitor has the appropriate capacity and withstand voltage value to provide a stable power supply voltage.
< br >
3. Inductive connection: Connect the inductor to the input and output filter choke pins of the TDA7388. Inductors are used to reduce the ripple of input and output signals and improve audio quality.
< br >
4. Output coupling capacitor connection: Connect the output coupling capacitor to the output coupling pin of the TDA7388. The output coupling capacitor is used to couple the audio signal of the speaker from the output to the speaker.
< br >
5. Input coupling capacitor connection: Connect the input coupling capacitor to the input coupling pin of the TDA7388. The input coupling capacitor is used to couple a microphone or other input signal to the input of the TDA7388.
< br >
6. Speaker connection: Connect the positive terminal of the speaker to the output pin of the TDA7388. The output of the TDA7388 is usually connected to the negative terminal of the speaker.
< br >
7. Input connection: Connect the negative terminal of the microphone or other input device to the input pin of the TDA7388. Note that the input pins should be connected to the negative supply voltage so that the TDA7388 correctly recognizes the input signal.
< br >
8. Check connections: After connecting all devices, be sure to check that all connections are correct. If there are problems, correct them.
< br >
When connecting the TDA7388 power amplifier chip, make sure to follow the correct connection sequence and use the appropriate power and ground connections. This will help ensure that the power amplifier chip works properly and provides good audio performance. If you are unsure about your connection, it is recommended to seek professional help.
The wiring mode of TD7388 power amplifier chip is as follows:
< br >
1. Power cable: Connect the positive power terminal to the VCC pin of the chip, and connect the negative power terminal to the GND pin of the chip.
< br >
2. Input signal wiring: The chip has four input interfaces, namely IN1, IN2, IN3 and IN4. Input the audio signal to the IN1 and IN2 interfaces, or IN3 and IN4 interfaces.
< br >
3. Output wiring: Connect the positive and negative poles of the speaker to the OUT1 and OUT2 pins of the chip, or connect to the OUT3 and OUT4 pins of the chip.
< br >
It should be noted that when wiring, pay attention to the wiring mode of the power supply and signal to ensure that the positive and negative terminals of the power supply and signal are not connected. At the same time, pay attention to the voltage and current of the power supply, so as not to exceed the rated working range of the chip.
With the typec interface, just plug it in