Altium designer many beginning to search the library is very hard, so want to write a tutorial, but I learn this software is less than two months, not experts, but throw a brick to introduce jade, which is not right also hope you a lot of advice
Tools\/Materials
Methods\/Steps
1, in the datasheet to find the component Package Dimensions (Package Dimensions) generally at the end of the file
< br \/ >
2, generally, we draw the package only need to care about the pin spacing, pad size and border size change line, see the datasheet can be seen that the component border size is 6mm*6mm, pin spacing is 1mm, pin length and width have tolerance range, we take the median value of 0.53*0.5, the center pad size is 4.14*4.14(take the median value), Knowing this, you can start drawing the package library in DXP, follow the steps below to create the PCB package library
< br \/ >
3. Change the package name
< br \/ >
4. Draw the border
< br \/ >
5. Modify the unit
< br \/ >
6. Draw borders
< br \/ >
7. Repeat the above steps to draw a square border
< br \/ >
8, place the pad, it should be noted here, because the pad of this package is all under the device, if it does not lead to a certain length is difficult to manually weld, but according to the datasheet description can not lead to nor can be used on the back of the hole, but I really have no better way, can only listen to the advice of the datasheet.
< br \/ >
9. Array
< br \/ >
10. Repeat the above steps to finish drawing
< br \/ >
11, can also be modified