To apply the anti-slip tape of the GPW generation mouse, perform the following steps:
1. Clean the bottom of the mouse: Wipe the bottom of the mouse with a cotton ball or a soft cloth to ensure that the surface is clean and free from dust or oil.
2. Prepare a non-slip sticker: Peel off the protective film on the back of the non-slip sticker and prepare one end of the sticker.
3. Determine the position of the sticker: Take the center of the bottom of the mouse as the reference point, align the end of the non-slip sticker with the bottom of the mouse, and keep the paper face up.
4. Stick the non-slip sticker: Put the sticker on the bottom of the mouse from one end, and gradually press the non-slip sticker flat on the bottom of the mouse, and ensure that it is aligned with the edge of the mouse. 5. Ensure that the non-slip sticker is firmly attached to the bottom of the mouse by gently pressing the sticker with your finger to ensure the best anti-slip effect. 6. Remove bubbles: If bubbles appear, you can use a hard straight edge tool such as a bank card to squeeze the bubbles along the edge of the sticker to ensure that the non-slip sticker fits the bottom of the mouse completely. 7. Shelve for a period of time: After pasting the non-slip sticker, it is best not to use the mouse immediately, and give the non-slip sticker a period of time to cure, to ensure that the viscosity is stronger.
Please note that the above steps are for reference only. In actual operation, please adjust according to the type and texture of non-slip stickers. Ensure that the mouse is clean and the anti-slip sticker is firmly attached to ensure that the mouse has a good anti-slip effect when used.
1, to paste GPW generation mouse anti-slip tape, first need to clean the bottom surface of the mouse to ensure that it is clean and dust-free.
2, then cut the appropriate size of the non-slip tape, stick it on the bottom of the mouse.
3, make sure to stick flat, no bubbles or wrinkles.