Rongda speed printing machine ink chip zero clearing method is as follows
First, press the power button, and then connect the power of the printer, and then press twice to stop\/reset, enter the \"SFP TEST MODE\"
< br >
2. Press \"\" to select\" 4 EEPROM DUMP& INFO \
< br >
Third, press the power button to shut down, restart, after self-test everything is normal. The display still shows ink mismatch or less ink, but this does not affect use.
< br >
1, in the shutdown state, press and hold the \"Stop\/reset\" button, and then press \"Power\" to start
< br >
2, keep the \"power\" button is not loose, release the \"stop\/reset\" button, and then press the \"stop\/reset\" button twice (this is to enter the maintenance mode)
< br >
3. Wait until the printer stops and the LCD displays \"0\
< br >
4. Press the \"Power\" button twice to save the Settings.
Because the ink chip of Rongda speed printing machine is a separate circuit chip, it is necessary to directly contact the ink chip under the guidance of professional maintenance personnel, and use professional tools for zero clearing, you need to have certain professional skills and experience
If you do not have zero clearing skills, you can consult Rongda speed printing center, Or go to a professional printer repair shop for repair, but it needs to cost a certain amount of money, but it can ensure the repair effect and protect the long-term use of the printer
Rongda speed printer ink chip can be cleared
When Rongda speed printer ink chip tips " The ink cartridge has run out. You can press and hold the " on the printer. Go on. Key seconds, until the light is on, the counter inside the printer is zeroed, and the counter zeroed information is sent to the ink chip
After zeroing you can continue to use the ink cartridge, but you need to pay attention to whether the ink is sufficient, if it has been exhausted, it needs to be replaced in time
1. Open the machine cover and ink cartridge cover of the Rongda speed printer, and then take out the ink chip.
2. Find a small hole on the ink chip, insert the hole gently with a fine needle or pin, and wait for about 5 seconds.
3. Then, take out the fine needle or pin, put the ink chip directly back inside the machine, close the ink cartridge cap and the machine cap.
4. Then restart it.
Hello, Rongda speed printing machine ink chip zeroing steps are as follows:
1. Open the lid of the printer and remove the ink cartridge.
2. Locate the chip on the top of the cartridge and wipe the chip surface with alcohol on a cotton swab or soft cloth.
3. Reinstall the cartridge into the printer, close the lid, and turn on the printer.
4. Connect the printer to your computer, open the printer software, and select \"Cartridge Information\" or \"cartridge status\".
5. Click the \"Clear\" or \"Reset\" button to confirm the operation.
6. Close the software, restart the printer, and check whether the ink cartridge status is cleared successfully.
considerations
1. Exercise caution when performing operations to avoid damaging the ink cartridge or printer.
2. The zero clearance operation may affect the warranty of the printer, which should be carefully considered.