1. Rotate the back shell first, and then install the battery. There are reflective materials on the back shell. This design is still very careful, and the back will not leak light when the light is on.
2, into the own three five batteries, and then card on the buckle, the buckle design is a bit like the four-wheel drive battery buckle when I was a child, gently click on the buckle.
3, open the Mijia APP, the connection prompt will pop up automatically. The operation is also very simple, the left and right wave configuration switch or shake your hand in front of the light can open the connection, select the room that needs to be placed, this is still more critical, especially in the case of more equipment, the device linkage will be more clear.
4. When the connection is completed and the device interface is entered, we can see that the main interface is the execution log of the light, the bottom of the two modules are the night light setting and the intelligent scene, and the upper right corner is the general setting. We need to update the firmware to the latest version first. Note that since this nightlight is a Bluetooth device, upgrading the firmware needs to be done near the nightlight. At the same time, it is also necessary to be near the night light when setting the night light.
In the nightlight setting interface, we can see that the first nightlight function can be turned off, but it does not affect the sensor function, and it can also save power. The following is the night light setting, the setting range is 1%-100% (2.5lm-25lm), the lighting time setting, the setting range is 15-60 seconds, and finally the setting of the ambient light induction light and dark limits, from dark to brighter there are five levels. In general, the night light is used in a relatively dark place, so I think it can be set in the dark or dark.