Because when the Bluetooth headset detects a wireless network, it usually automatically connects. This indicates that there is a fault in the charging bin. Try to take out the headset and put it in again to charge, or check whether the data cable and interface are not well connected. The charger and battery are faulty, which can be detected or replaced
< br >
It is recommended to reset the headset first by holding down the function key for 10 seconds and waiting for the white light to blink. After the reset is successful, put it in the headset bin and disconnect it.
for the following reasons
Mainly because the headset cover is not tight enough, loose will lead to the Bluetooth headset can continue to connect.
We can fix the ear compartment, so that it will not be connected after Gates, he will actively shield the Bluetooth signal, or we can turn off the Bluetooth switch directly on the phone.
Because the design of the headphone charging box card is not good enough, when the headphone is put in, it always needs to be repeated many times to get the card good, which leads to this situation.
There may also be a problem with the charging needle of the charging box or something dirty, which can be wiped to see if there is any improvement.
Generally speaking, when the earphone is put into the charging box, it will automatically shut down, and if the earphone is not saturated, it will automatically charge, and there is no need to move it repeatedly.