1, the tool holder is too high or too low, the packaging speed is too fast, the push rod and the cutting tool are not synchronized, the cutting tool will cut on the product maintenance method is to reduce the packaging speed, adjust the height of the end sealing parts, so that the center of the sealing tool is in the middle of the product height
2, the color of the film color label is too light, the film drive slip, the color label tracking is not opened when the cutting position deviates from the color label, then the maintenance method is to refer to the packaging machine manual, adjust its sensitivity; In the human-machine dialog interface, switch the tracking mode to \"Tracking Cut\"
3, the temperature is too high, the speed is too slow, the heat resistance of the outer layer of the envelope is poor, the sealing will appear coke wrinkles traces maintenance method is to adjust the speed, reduce the temperature, replace the film material
4, the solid state breaker is burned out, the temperature control meter is damaged, the temperature meter can not control the temperature when the thermocouple is damaged, the maintenance method is to replace the electric couple, replace the temperature control meter, replace the heating body
5, the air pressure is not correct, the cylinder swing rod is loose, the heating temperature is low, the hot press roll and the drive roll are not parallel when the heat seal is poor, the maintenance method is to adjust the parallelism, adjust the temperature and air pressure to tighten it
6, the speed is too fast, the inner layer of the envelope is poor in heat sealing, the temperature is too low, the sealing will leak or not firm, the maintenance method is to slow down the speed