Welding Apple charging cable requires a certain technology and operation method. Below I will follow the steps to show you how to weld an Apple charging cable.
< br >
1. Prepare tools and materials:
< br >
- A broken apple charging cable
< br >
- Welding iron and its support
< br >
- Solder the tin wire
< br >
- Wire strippers
< br >
- Insulation tape
< br >
2. Peel off the cable skin:
< br >
Using wire strippers, gently peel the outer skin off both ends of the Apple charging cable until the insulation inside the wire is exposed. Make sure not to strip the internal wires to avoid short circuits or other problems.
< br >
3. Connect cables:
< br >
- Insert each end of the stripped wire into the bracket of the welded iron, and preheat the welded iron to the appropriate temperature. Follow the instructions for welding iron.
< br >
- Wait for the welding iron to reach the predetermined temperature, and then gently apply the welding tin wire to the welding iron head to maintain good thermal conductivity.
< br >
- Place the exposed parts of the two wires close to the welded iron ends so that they touch together. Make sure the connection is strong and there are no exposed wires.
< br >
- Gently touch the head of the welding iron to touch the two wires, while using the other hand to hold the welding tin wire close to the contact of the welding iron and wire.
< br >
- When the solder wire begins to melt, gently apply it to the joint. Ensure that the solder wire is fully melted and covers the entire joint area. This will ensure a strong and durable connection.
< br >
- Wait for the welding point to cool, and check whether the welding is firm. If desired, the welding points can be wrapped with electrical tape for added security.
< br >
Please note that welding is a technical activity and requires caution. For those without relevant experience, if you are not sure if you can perform it correctly, seek help from a professional to avoid damaging the equipment or causing other safety problems.
Apple charging cable generally uses a four-core design, including positive and negative two power cables and two data cables. To weld the apple charging wire, you first need to prepare tools such as solder, welding table and solder wire.
Second, expose the wire end to about 1.5cm of insulation, and use a wire stripper to peel off the outer skin.
Then, use a tin suction to remove the tin residue of the power cord, and sand the wire with sandpaper to make the wire bright.
Then, the welding foot is preheated through the welding table, and the wire is connected to the welding foot with solder, and the heat is continued until the welding is complete.
Finally, clean the welding spot with an alcohol cotton ball to ensure that the welding spot is free of contaminants.
After the welding is complete, use insulation tape or heat shrink pipe to protect the welding contacts from short circuit or electric leakage. The whole welding process requires patience and meticulousness to ensure welding quality and safety.
Solder Apple charging cable method is as follows
< br >
1. First, peel off 2 cm of the outer protective skin on both ends to expose the four wires inside.
< br >
2. Peel off the outer skin of the four wires to expose the inner wires.
< br >
3. Whether the wire is enameled under the multimeter, scrape the outer paint off.
< br >
4. Twist the two ends of the wire of the corresponding color together, and weld with a soldering iron if there is one.