< br >
1. Turn off the iphone6 first to avoid battery leakage when disassembling and damaging the battery of the iphone6.
< br >
2. Then use an iphone6 screwdriver to remove the two screws next to the charging port.
< br >
3. Because the screen of the iphone6 is glued to the back shell with waterproof adhesive, it needs to be heated to facilitate its removal and can be heated with a hair dryer.
< br >
4. Then insert your fingernail through the gap under the screen to separate the broken screen from the back shell.
< br >
5. Be careful not to use too much force when removing the screen, because the back line is connected to the screen, so as not to pull out the line.
< br >
6. Remove the Phillips screws from the iron plate of the battery buckle using an Apple screwdriver.
< br >
7. Then use the flat end of the small pry bar of the phone to slowly lift the battery connector and remove it.
< br >
8. Return to the old display assembly, remove the phillips screws from the handset mounting bracket, and remove the handset mounting bracket.
< br >
9. Next, remove the receiver, front camera cable, remove the fixing screws on the back cover of the LCD assembly, and then open the iron plate of the LCD assembly.
< br >
10. Next, remove the screws above the return key and remove the return key iron.
< br >
11. Finally, scoop down the rows on the return key.
Just unscrew the bottom two screws, then press and slide the back cover up. Specific methods and steps are as follows:
1. Unfasten the two tail screws on the cover using a screwdriver. Use a 5-star screwdriver or a Phillips screwdriver.
2. Push the shell upward. Generally, the shell can be pushed easily. Remove the casing and the operation is complete. Push down when installing, as shown in the flashback method above.