1. Slowly remove the black protective strip around the windshield using a flat screwdriver. Then remove the windshield wiper and the protective cover under the front windshield.
2. Use the steel wire strip to pass the sealant under the windshield, one person in the car, one person outside, pull back and forth, slowly pull the sealant apart until the whole windshield around the sealant is pulled apart.
3. Use a small blade to slowly scrape off the black sealant stuck on the car, and then use sandpaper for final removal. Until you see the color of the iron frame. Wipe the dust around the newly purchased windshield with a rag.
4. Use the purchased polyurethane sealant to apply on the frame of the car windshield, as thick as possible in a triangle or diamond shape. So that it can be well bonded to the glass.
5. When installing the windshield, pay attention to the two small brackets on the car, which are used to support the windshield, and be sure to support the windshield on the small support. Slowly squeeze, then apply a second layer of polyurethane sealant around the windshield to stick the black protective strip.
6. After installation, install the windshield wiper and lower protection plate, and use transparent tape to connect the windshield to the roof. It is best not to travel immediately after completion, it is best to place the car for two or three days, until the sealant is completely condensed.
Here are the steps to remove the front windshield bracket of a BMW G38:
1. Open the hood and remove the wiper and wiper arm.
2. Remove the two screws at the bottom of the support.
3. Remove the bumpers on both sides of the support.
4. Remove the bottom of the support and protect the windshield with rubber pads.
5. Finally, remove the support and clean the part where the bottom of the support meets the windshield.
Hello BMW new five series g38 door glass, to remove the door interior to remove, and then remove the rail bright strip from the above, and then insert special tools, pry open the fixed glass clip, and then use the hand to lift the glass from the inside. I hope my answer can help you.
The method of removing the front windshield bracket of the BMW g38 is:
Drop a liquid such as wind oil or asphalt cleaner between the bracket and the glue, and wait for a while to remove the glass bracket.