May be car wireless charging is useless Your car wireless charging is useless model is not supported. When using rx5max wireless charging, you need to put the mobile phone with wireless charging function on the wireless charging board Car wireless charging is useless , the location should beSet up car wireless charging no , you can charge, pay attention to the wireless charging panel supported by the mobile phone model is different.
Check the charging slot and mobile phone if there is no problem, you need to go to the 4S shop for repair. The wireless charging of the mobile phone is in the lower right side of the block pole there is a slot, plug the mobile phone into it, plug in the induction will automatically charge, do not need to open. As long as the mobile phone supports wireless charging, the car can start, if it can not be charged, go to the 4S shop to check.
This wireless charging function is to support wireless chargingThe mobile phone can only be used, and the mobile phone without wireless function cannot be used. First of all, your mobile phone should support wireless charging, and then put it into the wireless charging slot and you can have a reaction. Only the 4-drive version has wireless charging! . There is no wireless charging for the 5T, unless it is optional. The phone needs Settings. Only for high-spec cars.
Charging safety. High-power wireless charging equipment will produce a large amount of electromagnetic radiation 1653 radiation, which will cause certain adverse effects on human health, but also have interference effects on aircraft and communications.
1, BMW 530 wireless charging mobile phone no response may be caused by a variety of reasons, such as insufficient car battery, starter failure, driving computer failure, and battery pile head loose. These problems may cause the wireless charging system to not work properly. When encountering such problems, the owner can try to charge or replace the battery, check whether the starter and the driving computer are normal, and ensure that the battery pile head is tight.
2, when the BMW 530 wireless charging function cannot be used normally, canIt can happen for a variety of reasons. First of all, you need to check whether the battery is working properly, because the battery is out of power may cause the wireless charging to fail. If the battery is normal, then the failure of the starter or the failure of the driving computer may also lead to the normal use of wireless charging. In addition, the battery pile head loose may also be a cause. To answer this question more intuitively, let's first take a look at how wireless charging works.
3, the mobile phone does not turn on the wireless charging function. The phone did not respond to the wireless charger, mainly because the phone did not turn on the wireless charging function. Tap to open the "Settings" option on your phone. On the General Settings page,Turn on the "WPT Charging" function.
4, BMW wireless charging Apple phone did not respond to you can see if your phone has a case, take the shell off and try again. Wireless charging technology, derived from radio energy transmission technology, can be divided into low-power wireless charging and high-power wireless charging two ways. Low-power wireless charging often uses electromagnetic induction, such as the Qi method of charging mobile phones, but ZTE's electric vehicle wireless charging method uses induction.
5, because the BMW 530 has a wireless charging board in front of the shift lever, its size is relatively small, and the current mobile phone size is increasing, which will lead to mobile phonesMobile phone protection case is too thick, it is recommended to choose a thin mobile phone protection case or not use when using wireless charging. It may be that the phone is not aligned with the charging area of the wireless charger, it is recommended to check the wireless charger specification to determine the wireless charging area. It may be that the wireless charger is not suitable for the wireless charging system of the mobile phone, so it is recommended to use the charger that meets the wireless charging requirements of the mobile phone.
3, the phone case is too thick will affect the mobile phone charging coil and wireless charger induction, resulting in normal charging. Therefore, it is recommended to remove the protective case of the mobile phone before using the wireless charger to charge; The charging coil area in the mobile phone is small, if noThe incorrect placement of the phone during line charging will also lead to the failure to charge normally. The wireless charging coil is located in the center of the back of the phone, and can be placed on the surface of the wireless charger according to the position.
4, the phone case is too thick will affect the mobile phone charging coil and wireless charger induction, resulting in normal charging. Therefore, it is recommended to remove the protective case of the mobile phone before using the wireless charger to charge; The charging coil area in the mobile phone is small, and if the mobile phone is placed incorrectly when wireless charging is used, it will also lead to normal charging.
5, may be the mobile phone protective shell is too thick, it is recommended to use wireless chargingChoose a thin phone case or do not use it. The phone case is too thick will affect the induction of the charging coil and the wireless charger in the phone, resulting in normal charging. Therefore, it is recommended to remove the protective case of the mobile phone before using the wireless charger to charge; The charging coil area in the mobile phone is small, and if the mobile phone is placed incorrectly when wireless charging is used, it will also lead to normal charging.